Cygnus 6510 Bedienungsanleitung PDF herunterladen (Seite 10)

IAGNOSTICS

NOTE: Commissioning Mode only activated when ENG is connected to 9-15vdc

Commissioning

Tones

Status Indicated Action

Single Click Tamper closing – front or rear

Use to ensure that the rear tamper has been

trimmed or extended to the correct length,

or that the cover has been fully closed.

Double Click Tamper opening – front or rear

Use to verify correct operation of tamper

circuit

Continuous slow

clicks

Rear tamper not closed when

cover tamper is closed

Remove unit from wall and adjust rear

tamper until it closes when the unit is

correctly fitted.

Continuous fast

clicks

Battery not connected or faulty

when cover tamper is closed

Open cover and check that battery is

correctly connected.

NOTE: Diagnostic LED only activated when Cover is open

Diagnostic LED Status Indicated Action

Single Flash Battery voltage low

Change battery (unless newly fitted and is

still charging)

2 Flashes

Battery test failed Change battery

3 Flashes

Piezo self test failed Change sounder

4 Flashes

Battery charger failure Change sounder

1 2 ... 5 6 7 8 9 10 11 12

Keine Kommentare

Cygnus 6510 Bedienungsanleitung Seite 10